Sat Commands Specific To The Avaya G350 And G700 Media Gateways - Avaya G350 Maintenance Manual

Avaya Communication Manager controlled maintenance
Maintenance commands
•
All Voice Media Modules and their associated ports can be busied out and released from the
busyout state on demand from the SAT.
NOTE:
A Communication Manager warning alarm and associated hardware error with error code
18 is generated when a Media Module is busied out.
•
All Media Modules can be reset on demand from the SAT by use of the
CAUTION:
This is a destructive command so the Media Module must be busied out before a demand
reset can be done.
•
If an invalid G350 number is entered with the test command for a Media Module board or port,
the following message is displayed:
•
Tests that are called for but that cannot run on a Media Module abort with the abort code 1412.
•
A request for a demand test, a reset, or busy out of the module (board) location for the S8300
Media Server aborts.
SAT commands specific to the Avaya G350
and G700 Media Gateways
In traditional servers running Communication Manager, ports are identified by the cabinet number,
carrier, slot, and port (e.g., 01A0704). This naming convention does not make physical sense for Media
Modules. Therefore, a new convention was developed that meets the needs of the Avaya G350 and G700
Media Gateways, yet for portability to traditional administration maintains the 7 character field. Also, in
traditional server administration there are many commands that either require port fields as an argument
to the command or require a port field value be entered on the form. Therefore these commands need to
understand Media Module port fields and accept them as valid entries. This applies to both the S8300
Media Server and an external communications controller, whether it be an S8700 Media Server or
another server. The media gateway format is GGGVMPP, where GGG is the media-gateway number, VM
is the module slot number, and PP is the port number.
NOTE:
The V, for virtual, is a required character that is part of the module slot number (H.248
terminology).
The following subsections describe the commands unique to the Avaya G350 and G700 Media Gateways:
•
add/change/display/status media gateway [x, next]
•
list media-gateway
•
list configuration media-gateway
•
status media-gateway
50
"xxxx" port/board is not valid
Maintenance of the Avaya G350 Media Gateway
reset board command.
.
June 2004