Digital Line Electronic Power Feed Test(#11) - Avaya G350 Maintenance Manual

Digital Line Electronic Power Feed Test(#11)

MM711 boards provide power to the terminals. Therefore this will be an EPF restore test. The test
procedure and its response is same as that of EPF. If the over current persists the power will be shut off
automatically and an EPF_off_overcurrent message is sent uplink.
Table 66: TEST#11 Digital Line Electronic Power Feed Test 1 of 2
Error Test
Code Result
ABORT
1000 ABORT
Maintenance of the Avaya G350 Media Gateway
June 2004
Avaya Communication Manager controlled maintenance
Description/ Recommendation
Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The port may be
busy with a valid call.
Enter display port GGGVSpp to determine the station extension or
attendant number of the port. Use status station or status attendant to
determine the service state of the port. If the port is in use, wait until the
port is idle before testing. Attendants are always in use (off-hook) if the
handset is plugged in and the port is not busied out.
If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
DIG-LINE (Digital Line)
1 of 2
125