Setting The Vector Checker - Epson S5U1C17001C Manual

5 gnU17 iDE

5.7.6 Setting the Vector Checker

Set the options for the vector checker. When you use the coprocessor library, select or unselect the checker that
verifies whether the emu_copro_process interrupt function is allocated to the vector table.
(1) Select the project to be built in the [C/C++ Projects] or [Navigator] view.
(2) Select the [Properties] command from the [Project] menu or from the context menu of the above view. This dis-
plays the [Properties] dialog box.
(3) Select [GNU17 Build Options] in the property list.
(4) Select [Vector Checker for Copro] from the tree list of [Build Options].
[Command:] indicates the program name of the vector checker, while [All Options] indicates the options cur-
rently set.
(5) Select the category from the tree list of [Vector Checker for Copro] and set the required options.
(6) Click the [Apply] button to change other properties or the [OK] button to end property settings.
After you change the settings, a dialog box appears inquiring whether to execute the "clean" build (refer to Sec-
tion 5.7.8). You can remove (and rebuild) the file generated under the old settings.
If you haven't clicked [Apply], you can use the [Revert Settings] button to discard the changes made and restore
the status in which this page was opened.
Shown below is the page for setting vector checker options.
[general]
[Check if 'emu_copro_process()' is allocated to vector No. 3]
(default: ON if the coprocessor library is used)
5-124
EPSOn
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
S5U1C17001C ManUal