Epson S5U1C17001C Manual page 351

Cmos 16-bit single chip microcomputer, c compiler package for s1c17 family

Hide thumbs Also See for S5U1C17001C:

Table of Contents

[Boot vector address] (effective only in simulator mode)

Enter the boot vector address in hexadecimal notation (omit 0x) in the text box when creating a command

file for simulator mode. The address may be specified in 256-byte increments. The IDE generates a com-

mand file for simulator mode that includes a command for setting this value to the boot vector address. The

value appeared here by default is the address that was specified when the project was created.

Selecting ICD Mini or Simulator in [Debugger:] sets the port to USB or NONE, respectively. So no settings

are required.

Applies the above settings to the command file shown in the [GNU17 GDB Commands] page and closes

the dialog box. A dialog box appears prompting overwrite, so execution may be canceled even after the but-

ton is clicked.

Close the dialog box. The command file shown in the [GNU17 GDB Commands] page does not reflect the

contents changed in the dialog box.

When you change the target CPU or memory model in the [Properties] > [GNU17 General] page, this dialog

box is restored to default settings (for ICD Mini).

S5U1C17001C ManUal

(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)