Epson S5U1C17001C Manual page 608

10.8.3.3 Error Messages Displayed by Profile Window and Coverage Window
Errors are displayed in the message box (provided with an [OK] button).
Measurement results are not displayed after you click the [OK] button.
An error is displayed at the time a window is opened or a profiler measurement data file is loaded.
Message
No profiling data.
This file is not profiler format.
This file is not C17 architecture.
not enough memory.
Version mismatch.
Program called too many functions.
Program called too deep functions.
Cycle counter was overflowed.
Function address were overlapped
unexpected error occured in GDB.
Merging mismatch (Function name)
Merging mismatch (Start or End address)
S5U1C17001C ManUal
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
Table 10.8.3.3.1 Error messages
The profiler measurement data file cannot be found.
The size of the specified profiler measurement data file is 0.
The specified file is not for C17. The ID is not "C17PROF."
Adequate memory area could not be secured in the PC.
The version of the profiler measurement data file is not
supported. The tool version differs from the version used to
create the measurement data.
The program called more than 10,000 different functions.
The program made more than 10,000 deep calls as viewed from
the top function.
The cycle counter exceeded 32 bits.
An overlap in function address occurred.
Measurement was not conducted properly. Restrictions may
have been violated (e.g., there is no assembler source type
declaration; refer to Section 10.8.8.4, "Restrictions.")
The function names and the number of functions at the merge
source and merge destination failed to match.
The starting addresses and ending addresses at the merge
source and merge destination failed to match.
EPSOn
10 DEBUggEr
Description
10
Debugger
10-157