Epson S5U1C17001C Manual page 257

[Load map address]
If you selected [LMA ≠ VMA], set the address at which you want to store the section. If you want to lo-
cate the section following another section, select the section immediately preceding from the pull-down
list. To locate the section at the beginning of a device or apart from the preceding section, enter the ad-
dress of that location (in hexadecimal notation).
note: When entering an address, use only 0–9 and A–F. Make sure that the address entered is
six characters or less. Otherwise, your entry will be interpreted as a section name, not an
address.
Use the lower part of the dialog box to set the location information on objects in the section.
The contents shown below may be changed only in user sections. The standard sections are predefined so
that all object files for the project and the libraries already set in build options will be located. When a user
section is defined, the settings of the standard section with the same attribute will be automatically updated
to avoid overlaps.
[File Attributes]
Select an attribute from the pull-down list. Selectable attributes are the same as those of the standard
sections.
The standard sections do not allow changing of the attribute.
Unselected file list (left)
Lists the object files of the project and the libraries already set in build options not located in this user
section. Even before a build process, a list of object files is created from the source file names in the
project. Select objects to be located in this section from the list.
In a standard section, this list may be blank or the objects that have been located in user sections with
the same attribute are listed in unselectable status.
Selected file list (right)
Lists the object files and libraries located in this section.
In a standard section, all object files of the project and the libraries already set in build options locatable in
this section (except those are located in user sections with the same attribute) are listed here. When linked,
sections with the same attribute as that of an output section are extracted from within these files and listed in
the output section in given order, beginning with the top of the list. The object files are listed in alphabetical
order, after which the libraries are listed in the order in which the build options are set.
The list in standard sections is automatically updated according to the user section settings. It cannot be ed-
ited manually in contrast to user sections.
In user sections, the file configuration can be changed with the [<], [>], [Up], and [Down] buttons.
[>]
Selects a file to be located in this section from the unselected file list. This button is ineffective for stan-
dard sections.
[<]
Moves a file not to be located in this section from the selected file list to the unselected file list. This
button is ineffective for standard sections.
[Up]
Changes the location of objects within the section. When you select an object in the selected file list and click
this button, it swaps positions with the object immediately above it. This button is ineffective for standard
sections.
[Down]
Changes the location of objects within the section. When you select an object in the selected file list and
click this button, it swaps positions with the object immediately below it. This button is ineffective for
standard sections.
[Select All]
Selects all entries in the respective lists. This button is ineffective for standard sections.
S5U1C17001C ManUal
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
EPSOn
5 gnU17 iDE
5
IDE
5-135