Load (Load Program)[Icd Mini / Sim] - Epson S5U1C17001C Manual

Cmos 16-bit single chip microcomputer, c compiler package for s1c17 family

Hide thumbs Also See for S5U1C17001C:

Table of Contents

(load program)

Loads the program and data from elf format object files into target memory.

load [ Filename ]

Filename: Name of object file in elf or Motorola S3 format to be debugged (with path also specifiable)

When this entry is omitted, the file specified previously by the file command is loaded. This

specification is usually omitted.

Usage example

(gdb) file sample.elf

(gdb) target sim

The program and data are loaded from sample.elf in the current directory (specified by the file

command) into target memory (computer memory in this example because the debugger operates in simulator

• The load command must be executed after the file and target commands. The following shows the

basic sequence of command execution:

(gdb) c17 rpf sample.par (sets map information.)

(gdb) file sample.elf

(gdb) target sim

(gdb) c17 rst

• The load command loads only several areas of an object file containing the code and data. All other areas

are left intact in the previous state before load command execution.

• The size of file that can be downloaded for debugging is a maximum of 1,024 bytes per block (set down-

load-write-size 1024). Setting a greater value will cause the debugger to operate erratically.

(loads debugging information.)

(connects the target.)

(this command)

(resets the CPU.)

(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)

[ICD Mini / SIM]

S5U1C17001C ManUal