Chapter 4 Setting U P Equipment - Epson S5U1C88000H5 Manual

4 S
CHAPTER
Connect the equipment as shown in Figure 4.1.
Note: Be sure to turn all the system equipment off before installation and connection.
To DC 5V IN
AC cable
AC adapter
(1) Installing the Peripheral Circuit Board
Install the Peripheral Circuit Board for the model to be developed to the S5U1C88000H5. The target
board is connected to the Peripheral Circuit Board. Refer to the Peripheral Circuit Board manual of
each model for how to install the Peripheral Circuit and target boards.
(2) Connecting the USB interface cable
Connect the S5U1C88000H5 to the personal computer using the USB interface cable supplied in this
package.
(3) Connecting the AC adapter
Be sure to use the AC adapter supplied in this package for supplying power to the S5U1C88000H5.
Connect the DC cord plug of the AC adapter to the DC 5V IN connector of the S5U1C88000H5. For the
AC adapter, connect the AC cable supplied in this package. Use the same ground line between the
S5U1C88000H5 and the host computer.
Note: Make sure that the equipment is installed and/or connected properly before turning the power on.
The USB interface cable can be hot plugged.
S5U1C88000H5
(S1C88 FAMILY IN-CIRCUIT EMULATOR)
U
ETTING P
Peripheral Circuit Board
DIAG
ON/OFF
S5U1C88000H5
USB I/F cable
Fig. 4.1 Connection of S5U1C88000H5 system
EPSON
E
QUIPMENT
USB port
4 SETTING UP EQUIPMENT
Personal
computer
5