Epson S5U1C17001C Manual page 528

10 DEBUggEr
Notes
• To run the program from the beginning, execute c17 rst (reset) before the continue command.
• The continue command with IgnoreCount specified can be executed on condition that the target program
has been executed at least once and is currently halted because break conditions are met. In this case, a break
caused by the [Stop] key is not assumed since break conditions are met. If IgnoreCount is specified while the
target program has never been made to break once, the specification is ignored.
• If the target program has been halted by one cause of a break, and the continue command is executed with
IgnoreCount specified after clearing that break setting, an error is assumed. The same applies when other
break conditions have been set.
• If break conditions other than the one that stopped the target program must be ignored a specified number
of times, specify break conditions and the number of times that a break hit is to be ignored in the ignore
command. Then execute the continue command without any parameters.
10-78
EPSOn
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
S5U1C17001C ManUal