10.11.2 Starting and Terminating ES-Sim17
Starting up ES-Sim17
The debugger launches the ES-Sim17 when the following two conditions are met:
1. The parameter file read in the debugger has the comment below.
ESSIM <model name>
Example: ESSIM S1C17701
When the parameter file is created by the IDE, this comment is written to it according to the target
processor selected.
2. The target sim command (to set the debugger in simulator mode) is executed.
When the ES-Sim17 starts up, the [ES-Sim] window appears.
Terminating ES-Sim17
The ES-Sim17 terminates in the following two cases:
1. When the detach command is executed in the debugger
2. When the debugger is terminated
Opening/closing the [ES-Sim] window
The [ES-Sim] window can be closed by clicking the [Close] button. (This operation does not terminate the ES-
Sim17.)
To reopen the window, execute \essim17\EssWnd.exe. Note, however, that the ES-Sim17 must be running at
that point. If the ES-Sim17 has already terminated, execute the target sim command again.
The [ES-Sim] window cannot be opened twice. If you attempt to open the window when it is already opened,
the [ES-Sim] window moves to the foreground but a new window does not appear.
S5U1C17001C ManUal
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
EPSOn
10 DEBUggEr
10
Debugger
10-167
Need help?
Do you have a question about the S5U1C17001C and is the answer not in the manual?