Table of Contents
Advertisement
Fridge 369
Starting the refrigerator box
Hold in the switch (2) for about one second. The green
1
2
3
4
5
LED (3) lights up and the compressor starts. The
compressor will only start if the battery voltage is
8
higher than 24.2 V. If the battery voltage is lower, the
LED (3) will start to flash red. For further information,
see "Voltage monitor".
J209124
Adjust the temperature by holding down the
temperature selectors marked "–" (4) or "+" (5). The
selected temperature is shown in the digital display (1)
and flashes twice before the display shows the current
temperature in the refrigerator box. The LED
continues to flash green until the selected temperature
is reached. Once the selected temperature is reached,
the LED lights green continuously. When the
temperature rises to a level above the selected
temperature, the compressor starts and the LED
flashes green as long as the compressor is running.
Switching off the refrigerator box
Hold in the switch (2) for about 1 second. The green
LED goes out and the compressor
stops. If the refrigerator box is not going to be used for
a period of time, it should be cleaned thoroughly. See
"Cleaning". After cleaning, the cover should be held
wide open for at least 24 hours so that all the vapour
vanishes and no bad smells occur.
Voltage protector
To protect the battery from over-discharging, the
compressor is automatically turned off if the voltage
becomes too low. If the battery voltage is or has been
too low, the LED flashes red and the compressor does
not start. See also heading "Fault tracing". The voltage
monitor breaks at 22.8 V and restarts again at 24.2 V.
If the LED flashes red with a lightning flash despite
the battery voltage being normal, this is because the
voltage has earlier been too low. Start the engine to
Advertisement
Table of Contents
