Table of Contents
Advertisement
If manual regeneration fails, the
message "Regeneration failed . Check system
conditions." is shown in the display. To find out why
the regeneration failed, select "System conditions"(see
below) and check the system conditions.
Abort regeneration
Regeneration can be aborted at any time by:
• turning off the ignition, or
• deactivating ATS (see below)
Activate/Deactivate ATS
To activate/deactivate ATS:
1
Choose "Activate/deactivate regeneration" with
▲ and ▼.
2
Confirm with "SELECT"
3
Abort with "Esc"
When ATS is deactivated, the following symbol is
shown on the display. Reactivated ATS as soon as
possible.
System conditions
This function shows the status of the system
conditions that must be fulfilled for regeneration to
start (applies only to manual start of regeneration).
The system conditions can have the status OK,
CHECK or N/A. For regeneration to function, all
conditions must have status OK. If any of the
conditions has status CHECK, then regeneration
cannot be performed. N/A means that the condition
does not apply to this truck. See all the system
conditions below.
Information display
Note!
If regeneration is performed while
the engine is idling, the idle speed
may rise.
59
J129144
Advertisement
Table of Contents
