Table of Contents
Advertisement
380 Alcolock
6 Blow sufficiently hard into the nozzle. Continue to
blow until you hear a peep and the handset clicks. The
LCD display should then show "Wait".
If you blow incorrectly, the LCD screen will show
either "Blow less hard" or "Blow longer and harder".
Wait unit the hand unit shows "Test again".
Note the message on the handset.
• If "Drive safely" is shown in the LCD display and
the status lamp shows a green light, you have
managed the test. You can continue to drive the
vehicle.
• If "Stop, Switch off engine" is shown in the LCD
display and the status lamp flashes red, you have
exceeded the permillage limit. You must stop the
vehicle safely and switch OFF the engine. Wait
until the restart and lock timer stop before you do a
new breath test.
Energy conservation
The ALCOLOCK can be placed into sleep mode after
the motor has been turned OFF. In sleep mode, the
ALCOLOCK will operate at minimum power to
conserve energy in your vehicle battery.
To place the ALCOLOCK into sleep mode, simply
press and hold both buttons. Alternatively, you can
wait until the sleep timer expires. You can choose
from 4 sleep times as described below.
Advertisement
Table of Contents
