Table of Contents
Advertisement
322 Cab
As warm as possible
• Open all the ventilation nozzles
• Set the fan to AUT
• Set the air distribution in AUT
• Set the temperature to maximum heat
When the temperature control is at an end position and
the fan is set to AUT, the system will provide the
maximum fan speed.
Remove mist and ice from windows
• Check that recirculation is turned off
• Set the fan to AUT
• Set the air distribution to defroster
• Set the temperature to maximum heat or the fan to
max
In AUT/defrost mode with cold outdoor temperatures,
the windscreen can become so warm that snow smoke
melts on it. This can cause the wiper blades to freeze
to the windscreen. Set the air distribution to the floor
only. The floor setting can also be used together with
the defroster to remove mist from the side windows.
Clean the inside of the windscreen with a normal
window cleaning fluid to reduce the risk of misting up.
Clean more frequently if someone smokes in the cab.
With cold outdoor temperatures, mist and ice can
occur on the side windows. To avoid this, close the
inner panel nozzles and aim the side nozzles at the side
windows.
Note!
Do not use recirculation with high
humidity or heavy rain. It is
necessary to draw in new air and
have the AC on to prevent the
windscreen from misting up. If the
defroster has been selected, the AC
operates at maximum (except at low
temperatures) to dry the air.
J200702
J200699
Advertisement
Table of Contents
