Table of Contents
Advertisement
Information display
72
Vehicle data
Oil level
The truck has an electronic oil level sensor.
The bar marked min and max shows the engine oil
level. The figure in the middle shows how many litres
between min and max levels.
The engine oil level is also shown when the key is
turned to the ignition position. The level is shown for 5
seconds or until the engine has started and is shown
directly after the SRS and welcome message.
In order to show the correct value, the engine must
have been turned off for at least 70 minutes. If the
engine has not been turned off sufficiently long, the
display shows how many minutes remain until a
correct value can be shown.
If the oil level is "min" or below "min" a warning
symbol is shown.
Load indicator
The display shows indicated pressure on each axle,
indicated weight of the truck, indicated weight of the
trailer and indicated weight of the load. With bogie
and double drive axles the indicated weight on both
axles is shown. The values are updated every two
seconds.
See the separate driver instruction for more
information about the load indicator's function.
Brake lining, status
Shows the condition of the truck's brake linings.
Vehicle ID
The truck chassis number and the vehicle number that
were entered into the menu "Fleet ID" are displayed
here.
Note!
There is no warning for low oil level
while driving.
Note!
The oil level shall lie between "min"
and "max". Do not top up before the
level approaches "min". Too much
oil in the engine can increase oil
consumption.
Advertisement
Table of Contents
