Table of Contents
Advertisement
558 Maintenance
4
Remove the air vent hose from the filler plug (B)
and unscrew the plug
5
Fill with new oil until the level reaches the top
half of the maximum and minimum oil levels on
the transparent level plug (A) (max and min oil
levels, see illustration)
6
Apply a layer of thread sealant to the threads of
the filler plug (B) and screw the plug on. The
pipe on the plug should have the same orientation
(pointing diagonally upwards) as before removal
7
Install the air vent hose
8
Refit any sound baffles under the gearbox
Change oil and filter
Drain the oil immediately after driving. Then it has
low viscosity.
1
Untighten the drain plug.
2
Unscrew the screws holding the oil filter housing
(1).
3
Remove the filter housing (1).
4
Pull out the old filter (2).
5
Clean the sealing surface between the filter
housing and the gearbox.
6
Replace the gasket.
7
Fit the new filter.
8
Screw on the filter housing.
9
Fit the drain plug.
Caution!
Hot oil can cause burns.
Note!
The support tube in the centre of the
filter must not be removed /
replaced.
J1006732
J1007661
Advertisement
Table of Contents
