Table of Contents
Advertisement
Information display
66
• If it still will not work, perform diagnostics of the
display and engine control unit, see section "Fault
diagnosis".
• Contact a workshop if necessary.
Fuel (target)
Only accessible if correct password is entered.
This function makes it possible for the carrier to set a
fuel consumption target. For information about fuel
consumption for a journey, see section "Trip data".
1
Select Fuel (target) with ▲ and ▼.
2
Confirm with "SELECT".
3
State a new fuel target
Set the first digit with ▲ and ▼
Step to the next digit using "SELECT"
Step backwards with "Esc"
4
Confirm the new fuel target with "SELECT"
5
The message "Transfer complete" is shown
If the setting fails:
• Press "Esc" and try to do the setting one more time,
see point 1.
• If it still will not work, perform diagnostics of the
display and engine control unit, see section "Fault
diagnosis".
• Contact a workshop if necessary.
Ammeter sensor calibration
Ammeter sensor calibration must be performed when a
sensor or instrument is replaced.
Follow the instructions on the display. Cancel by
pressing "Esc".
Fleet ID
Only accessible if correct password is entered.
Advertisement
Table of Contents
