Table of Contents
Advertisement
Refrigerator 365
Starting the refrigerator
Hold the switched marked "ON/OFF" (1) in for about
1 second. The green LED (2) lights up and the
compressor starts. The compressor will only start
when the battery voltage exceeds 24.2 Volts. If the
battery voltage is lower than this, the green light diode
(2) begins to flash.
Adjust the temperature by holding down the
temperature selector marked "TEMP" (3). The blue
LEDs (4) light one after the other and continue as long
J0010488
as the temperature selector is held in. Select
temperature by releasing the temperature selector
when the correct number of LEDs light. The greater
the number of blue LEDs that are lit, the lower the
temperature in the refrigerator. The normal setting is
five blue LEDs lit, which gives a temperature of about
+6ºC in the coolbox at normal surrounding
temperatures.
Turning off the refrigerator
Hold the switched marked "ON/OFF" in for about 1
second. The green light diode goes out and the
compressor stops. If the refrigerator is not going to be
used for a period of time, it should be cleaned
thoroughly. After cleaning, the door should be held
wide open for at least 24 hours so that all the vapour
vanishes and no bad smells occur.
Voltage protector
To protect the battery from deep discharging, the
compressor is automatically turned off if the voltage
becomes too low. If the battery voltage is or has been
too low, the LED flashes green on the control panel
and the compressor does not start. The voltage monitor
disconnects at 22.8 V and reconnects again at 24.2 V.
If the LED flashes green despite the battery voltage
being normal, it is due to the voltage having been too
Advertisement
Table of Contents
