Table of Contents
Advertisement
Operating instructions
182
Starting engine
R
0
0
Off position
R
Radio position
1
Operating position
2
Start position
Door open
Starting engine
NOTE!
The machine's battery disconnector (main switch) is activated
when the ignition is turned from position 0.
NOTICE
1
Run the engine at low idling speed for at least half a minute after
start. This is to ensure the lubrication of the turbocharger.
2
If the machine is equipped with theft protection, see page
NOTE!
The engine can only be started with the gear selector in neutral
position.
1 Place the gear selector in neutral.
V1092158
2 Turn the key in the ignition to position 1 (operating position) so
3 At the same time, check that all symbols in the symbol row turn
4 At temperatures below 0 °C (32 °F):
5 Turn the key to position 2 (start position). If the engine does not
6 Check that all control and warning lights turn off.
7 Press down the brake pedal and release the parking brake.
8 Select gear position.
NOTE!
Sound the horn before moving the machine forward.
9 Let up the brake pedal and increase engine rpm with the gas
Speed limitation with open door
If the door is open the machine speed is limited to 8 km/h (5 mph).
If the door is opened and the machine speed exceeds 8 km/h (5
mph), the speed is limited to the current speed and then the speed
limitation drops with the machine speed down to 8 km/h (5 mph).
V1088300
For information on alarm display figures, see page
that the system test is run.
on and that the gauges show readings.
If the symbol for preheating flashes, leave the ignition in
position 1 (operating position) until the symbol turns off (see
section Information display unit under the heading Symbol
53 ).
fields on page
NOTICE
Do not use starting aids (ether, etc.). Serious engine damage
could result.
NOTE!
Never rev a cold engine, risk of serious machine damage.
start, turn back the key to position 0 before attempting to start
again.
pedal (accelerator).
105 .
84 and 98 .
Advertisement
Table of Contents
