Figure 57. Virtual media key installation
If you have other devices to install or remove, do so now. Otherwise, go to
page
100.
Installing the optional two-port Ethernet adapter
Use this information to install the optional two-port Ethernet adapter.
To install the Ethernet adapter, complete the following steps:
Step 1.
Read the safety information that begins on
41.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see
Step 4.
Remove the PCI riser-card assembly (if installed) from PCI riser connector 1 (see
riser-card assembly" on page
Step 5.
Attach the rubber stopper on the chassis, along the edge of the system board, as shown in the
following illustration.
"Safety" on page iii
"Removing the cover" on page
64).
"Completing the installation" on
and
"Installation guidelines" on page
48).
.
Chapter 2
Installing optional devices
"Replacing a PCI
81