Logging In To The Web Interface; Imm2 Action Descriptions - IBM Flex System x440 Compute Node Installation And Service Manual

Logging in to the web interface

Use these instruction to log in to the IMM2 web interface.
Notes:
v If you are logging in to the IMM2 for the first time after installation, the IMM2
v You can also assign IP addresses through the CMM ifconfig command. For more
v If the CMM and compute nodes are set to use DHCP and the CMM loses
To log into the IMM2 web interface, complete the following steps.
1. Open a web browser and in the Address or URL field, type IP adress or host
2. On the Login page, type the CMM user name and CMM password. If you are
3. Click Continue to start the session. The System Status page provides a quick

IMM2 action descriptions

Navigate to activities you perform with the IMM at the top of the IMM window.
The title bar identifies the user name that is logged in, allows you to configure
Settings for the status screen refresh rate and a custom trespass message, and Log
out of the IMM web interface. Beneath the title bar are tabs that allow you to
access various IMM2 functions, as listed in Table 2 on page 45.
For more information about the IMM2 actions, see
44
IBM Flex System x440 Compute Node Types 7917 and 2584: Installation and Service Guide
defaults to Dynamic Host Configuration Protocal (DHCP). If a DHCP host is not
available, the IMM2 assigns a static IP address of 192.168.70.125.
information about the CMM ifconfig command, see the "IBM Flex System
Management Module: Command-Line Interface Reference Guide" at
http://publib.boulder.ibm.com/infocenter/flexsys/information/index.jsp?topic=
%2Fcom.ibm.acc.cmm.doc%2Fcli_command_ifconfig.html.
connectivity to the network, the CMM attempts to acquire a new IP address
when network connectivity is restored. The compute nodes will not attempt to
acquire an IP address again, and the compute nodes continue to use their
existing IP addresses. Therefore, if you experience network problems on
compute nodes after connectivity between the CMM and the network has been
restored, you might have to reset the system management processor on each of
the compute nodes in the chassis (including IBM Flex System Manager
management software, if it is installed).
name of the IMM2 to which you want to connect.
using the IMM2 for the first time, you can obtain the user name and password
from your system administrator. All login attempts are documented in the IMM
event log.
Note: The IMM2 will log you out of the web interface if your browser is
inactive for 20 minutes.
view of the compute node status.