Table of Contents
Advertisement
of the I/O connectors.
RXE Management Port connector
Updating your server configuration
When you start your server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. See the User's Guide on the IBM xSeries
Documentation CD for more information about the Configuration/Setup Utility
program.
Some options have device drivers that you need to install. See the documentation
that comes with your option for information about installing any required device
drivers.
If your server comes with two microprocessors or if your server comes with one
microprocessor and you have installed one or more additional microprocessors,
your server can now operate as an SMP server. Therefore, you might need to
upgrade your operating system to support SMP. See the User's Guide on the IBM
xSeries Documentation CD and your operating-system documentation for additional
information.
If you have a RAID configuration on your server using the integrated SCSI
controller and you have installed or removed a hard disk drive, you might need to
reconfigure your disk arrays. See the User's Guide on the IBM xSeries
Documentation CD for more information about the LSI Logic Configuration Utility
program.
If you install a different type of RAID adapter in your server, use the configuration
method supplied with the RAID adapter to view or change SCSI settings for
attached devices.
The internal hard disk drives can connect only to the integrated SCSI controller with
RAID capabilities.
38
xSeries 450: Option Installation Guide
System power
System power
connector (2)
connector (1)
SCSI connector
USB 1 connector
USB 2 connector
RXE Expansion Port (B)
connector
Serial connector
Gigabit Ethernet
connectors
RXE Expansion
Port (A) connector
Video connector
Remote
Supervisor
Adapter
connectors
Advertisement
Table of Contents
