Table of Contents
Advertisement
Chapter 7
X330WAN CLI Commands
show fragment
Use the show fragment command to display information regarding fragmented
IP packets that are destined to the router.
Note: No fragmentation will be done of packets in transit through the router.
This command displays the following information:
•
Size - Maximum number of packets set by the size option.
•
Chain - Maximum number of fragments for a single packet set by the chain
option.
•
Timeout - Maximum number of seconds set by the timeout option.
•
Queue - Number of packets currently awaiting reassembly.
•
Assemble - Number of packets successfully reassembled.
•
Fail - Number of packets which failed to be reassembled.
•
Overflow - Number of packets which overflowed the fragment database.
The syntax for this command is:
show fragment
Example:
X330WAN-2DS1-1(configure)# show fragment
Max number of concurrently reassembled packets is 100
Max number of fragments per packet is 64
Fragment timeout is 10 sec
Number of packets waiting to be reassembled is 0
Number of successfully reassembled packets is 11954
Number of packets which failed to be reassembled is 0
Number of packets which overflowed the database is 0
show interfaces
Use the show interfaces command to display information on all interfaces in
the X330WAN, starting at the first Layer 2 interface. If the type is specified, only
interfaces of that type are shown. If no type is specified, all interfaces are shown.
144
Avaya X330W-2DS1 User's Guide
Advertisement
Table of Contents
Troubleshooting
