Ip Routing; Ip Routing-Mode (Interface Context); Ip Vrrp (Interface Context) - Avaya X330W2-DS1 User Manual

Chapter 7 X330WAN CLI Commands

ip routing

Use the ip routing command to enable IP routing. The no form of this
command disables the IP routing process in the device. By default, IP routing is
enabled.
The syntax for this command is:
[no] ip routing

ip routing-mode (Interface Context) ???

Use the ip routing-mode command to set the IP routing mode of the interface.
In RT-MGMT mode, the interface functions as a routing interface. In
RT_PRIMARY_MGMT mode, the interface function as both a routing interface and
the primary management interface. The IP address used in Avaya MultiService
Network Manager is the primary management interface IP address. Only one
interface can be in RT_PRIMARY_MGMT mode. By default, the first IP address
defined is used as the primary.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
ip routing-mode <mode>
mode
The syntax for this command for the X330WAN is:
ip routing-mode <rt_primary_mgmt>
Example:
X330WAN-2DS1-1(configure)# ip routing-mode RT_PRIMARY_MGMT

ip vrrp (Interface Context)

Use the ip vrrp command to create a virtual router on the interface. Use the no
form of this command to delete a virtual router.
Note: This command is executed from the Fast Ethernet and Fabric Fast Ethernet
interfaces.
82
RT_MGMT or RT_PRIMARY_MGMT mode
Avaya X330W-2DS1 User's Guide