Ppp Timeout Retry (Serial Interface Context); Queue-Limit (Serial Interface Context); Remote (Controller Context) - Avaya X330W2-DS1 User Manual

Chapter 7 X330WAN CLI Commands

ppp timeout retry (Serial interface context)

Use the ppp timeout retry command to set the maximum time, in seconds, to
wait for a response during PPP negotiation. Use the no form of this command to
restore the maximum time to wait for a response during PPP negotiation to the
default value (2 seconds).
The syntax for this command is:
[no] ppp timeout retry <Seconds>
Seconds
Example:
X330WAN-2DS1-1(config-if:Serial1:1)# ppp timeout retry 10

queue-limit (Serial interface context)

Use the queue-limit command to set the packet size of the various queues.
The syntax for this command is:
[no] queue-limit <queue id> <size>
queue id
size
Example:
X330WAN-2DS1-1(config-if:Serial1:1)# queue-limit 1 200

remote (Controller context)

Use the remote command to reset the far-end counters.
Note:
1. This command can only be performed if the controller is set to T1.
2. This command is used only when the fdl at&t option is defined.
138
The maximum time, in seconds, to wait for a response during
PPP negotiation. An integer from 1 to 255.
The queue priority ID (1 - highest, 4 - lowest).
The size, in packets, of the queue. The total amount of packets
in all queues cannot exceed 500.
Avaya X330W-2DS1 User's Guide