Speed (Fastethernet Interface Context); Timeout Absolute (Console Interface Context) - Avaya X330W2-DS1 User Manual

The syntax for this command is:
speed {9600|19200|38400}
9600
19200
38400
Example:
X330WAN-2DS1-1(config-if:CON)# speed 9600

speed (FastEthernet interface context)

Use the speed command to control the speed setting for the interface.
Note: This command is executed from the Fast Ethernet interface.
The syntax for this command is:
speed {10MB|100MB}
10MB
100MB
Example:
X330WAN-2DS1-1(config-if:FastEthernet1)# speed 100MB

timeout absolute (Console interface context)

Use the timeout absolute command to set the number of minutes until the
system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
timeout absolute <time>
time
Avaya X330W-2DS1 User's Guide
Sets a speed of 9600 bits per second.
Sets a speed of 19200 bits per second.
Sets a speed of 38400 bits per second.
Sets a speed of 10 Mbps.
Sets a speed of 100 Mbps.
Number of minutes (0-999) where 0 means no timeout should
occur at all.
WAN CLI Commands
149