Fragment Size; Fragment Timeout - Avaya X330W2-DS1 User Manual

Note:
1. This command can only be performed if the controller is set to T1.
2. Use this command only when framing esf is defined.
The syntax for this command is:
[no] fdl <fdl-mode>
fdl-mode
Example:
X330WAN-2DS1-1(configure)# fdl ansi

fragment size

Use the fragment size command to set the maximum number of fragmented IP
packets, destined to the router, to reassemble at any given time. Use the no form of
this command to set the fragment size to the default value (100).
Note: No fragmentation will be done of packets in transit through the router.
The syntax for this command is:
[no] fragment size <database-limit>
database-limit
Example:
X330WAN-2DS1-1(configure)# fragment size 150

fragment timeout

Use the fragment timeout command to set the maximum number of seconds to
reassemble a fragmented IP packet destined to the router. Use the no form of this
command to set the fragment timeout to the default value (10).
Note: No fragmentation will be done of packets in transit through the router.
Avaya X330W-2DS1 User's Guide
ansi | att | both
The maximum number of packets undergoing re-assembly at
any given time. The default is 100.
WAN CLI Commands
129