Show Controllers Remote - Avaya X330W2-DS1 User Manual

Severly Err
Secs
Unavail Secs

show controllers remote

Use the show controllers remote command to display far end performance
data through an fdl message.
Note: This command is used when the fdl at&t option is defined.
The syntax for this command is:
show controllers remote <port> <fdl-request-type>
port
fdl-request-
type
Example:
X330WAN-2DS1-1(super)# show controllers remote 1 1h-data
Avaya X330W-2DS1 User's Guide
For ESF (T1) signals, displays the number of seconds one of the
following is detected:
• 320 or more Path Code Violation Errors.
• One or more Out of Frame defects.
• An AIS defect.
For SF (T1) signals, displays the number of seconds one of the
following is detected:
• 1544 Line Code Violations.
• A count of one second intervals with Framing Errors.
• An Out of Frame defect.
For CRC (E1) signals, displays the number of seconds one of
the following is detected:
• 832 or more Path Code Violation errors.
• One or more Out of Frame defects.
For no-CRC (E1) signals, displays the number of seconds with
2048 or more Line Code Violations.
Displays the total number of seconds on the interface,
calculated by counting the number of seconds that the interface
is unavailable.
Number of the port.
Request types include:
• 1h-data
• Enhanced-CI-configuration
• Enhanced-1h
• Errored-ESF-data
WAN CLI Commands
143