No Ip Composite-Op; No Ip Distribution Access-List - Avaya X330W2-DS1 User Manual

Chapter 7 X330WAN CLI Commands
source port
destination port
established
Example:
X330WAN-2DS1-1(config-if:FastEthernet1)# ip simulate 100 in
192.67.85.12 193.76.54.25

no ip composite-op

Use the no ip composite-op command to delete a composite operation from a
policy list.
Note: This command is only supported by the X330WAN module.
The syntax for this command is:
no ip composite-op monitor <policy-list-number> <composite-
operation-index>
policy-list-number
composite-operation-index
Example:
X330WAN-2DS1-1(configure)# no ip composite-op 101 15

no ip distribution access-list

Use the no ip distribution access-list command to delete a distribution
list statement.
Note: This command is only supported by the X330WAN module.
The syntax for this command is:
no ip distribution access-list <access-list-number>
114
An integer (1..65535)
An integer (1..65535)
Value of TCP established bit
An integer (100..149), where 0 is the default
list.
Index of operation in the table to be deleted.
Indices 0 - 12 can not be deleted.
Avaya X330W-2DS1 User's Guide