Table of Contents
Advertisement
Chapter 7
X330WAN CLI Commands
ip admin-state (Interface context)
Use the ip admin-state command to set the administrative state of an IP
interface. The default state is up.
The syntax for this command is:
ip admin-state <up/down>
up/down
ip bootp-dhcp network (Interface context)
Use the ip bootp-dhcp network command to select the network from which
the bootp/dhcp server shall allocate an address. This command is required only
when there are multiple interfaces over the Fabric. The no form of this command
restores to the default.
Note: This command is executed from the Fast Ethernet and Fabric Fast Ethernet
interfaces.
The syntax for this command is:
[no] ip bootp-dhcp network <ip net>
ip net
Example:
To select the network 192.168.169.0 as the network from which an address shall be
allocated for bootp/dhcp requests:
X330WAN-2DS1-1(configure)# ip bootp-dhcp network 192.168.169.0
ip bootp-dhcp relay
Use the ip bootp-dhcp relay command to enable relaying of bootp and dhcp
requests to the bootp/dhcp server. The no form of this command disables bootp/
dhcp relay. The default state is: disabled.
The syntax for this command is:
[no] ip bootp-dhcp relay
68
Administrative state of the interface. The choices are
up (active) or down (inactive).
The IP subnet
Avaya X330W-2DS1 User's Guide
Advertisement
Table of Contents
Troubleshooting
