Checking The Modem Configuration; Configuring Fast Ethernet Interfaces; Configuring E1/T1 Interfaces - Avaya X330W2-DS1 User Manual

Checking the Modem Configuration

After establishing a modem connection, use the "show interface" console
command to display information regarding your network interface. Verify that the
output information is correct.

Configuring Fast Ethernet Interfaces

Before configuring Fast Ethernet interfaces, make sure the X330WAN is inserted in
the P330 switch and the power is turned on.
All CLI commands mentioned in this section are described in Chapter 7, "X330WAN
CLI Commands."
To configure Fast Ethernet interfaces:
1 Type "interface FastEthernet" 1 to enter the Interface Configuration
mode.
The prompt changes to X330WAN-2DS1-N(super-if:FastEthernet1)#
2 Use the "ip address" <ip address> <mask> command to assign an IP
address and subnet mask to the interface.
3 Type exit to return to Supervisor mode.
The prompt returns to X330WAN-2DS1-N(super)#
Note: For the first inteface to be configured the following message appears:
The primary management interface has changed.
For this change to take effect, you need to copy running-
config startup-config and then reset the device.
You need to issue the "copy running-config startup-config" and
"reset" commands.
Note: You cannot delete an interface if there is a primary management IP (PMI
defined on it).

Configuring E1/T1 Interfaces

Before configuring E1/T1 interfaces, make sure the X330WAN is inserted in the
P330 switch and the power is turned on.
All CLI commands mentioned in this section are described in Chapter 7, "X330WAN
CLI Commands."
For a list of X330WAN default settings, see "X330WAN Default Settings" on page 28,
or use the "show controllers" [<port>] command to display all of the
current settings.
Avaya X330W-2DS1 User's Guide
Configuring the X330WAN
23