Interface Serial; Keepalive (Serial Interface Context); Linecode (Controller Context) - Avaya X330W2-DS1 User Manual

X330WAN-2DS1-1(configure)# interface Loopback 1.0
X330WAN-2DS1-1(configure)# no interface Loopback 1.0

interface Serial

Use the interface Serial command to create and/or enter Interface Serial
configuration mode (context). For LAN interfaces, use this command to create the
interface. Use the no form of this command to delete an IP interface.
The syntax for this command is:
[no] interface Serial [port:channel-group[.ip-interface]]
port
channel-group
ip-interface
Example:
To enter Interface Serial mode port 1, channel-group 4 in ip-interface 1:
X330WAN-2DS1-1(configure)# interface Serial 1:4.1
Example:
X330WAN-2DS1-1(configure)# no interface Serial 1:4.1

keepalive (Serial interface context)

Use the keepalive command to enable keepalive. Use the no form of this
command to disable keepalive.
The syntax for this command is:
[no] keepalive [<Seconds>]
Seconds

linecode (Controller context)

Use the linecode command to select the line-code type for an E1 or T1 line. Use
Avaya X330W-2DS1 User's Guide
The controller number (port number) for this serial port. For
the X330W-2DS1, this value is either 1 or 2.
An integer. For E1, between 0 and 30; for T1, between 0 and 23.
The IP interface number within this interface (as a number of IP
interfaces might be bound to an L3 interface). An integer
between 0 and 1024.
An integer (0-32767). Entering keepalive without a
parameter will return the keepalive to its default of 10 seconds.
Entering keepalive 0 will disable keepalive.
WAN CLI Commands
133