Ip Rip Default-Route-Mode (Interface Context); Ip Rip Poison-Reverse (Interface Context) - Avaya X330W2-DS1 User Manual

Chapter 7 X330WAN CLI Commands

ip rip default-route-mode (Interface context)

Use the ip rip default-route-mode command to enable learning of the
default route received by the RIP protocol. The default state is talk-listen. Using the
X330WAN, the no form of the command disables listening to default routes.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip rip default-route-mode <mode>
The possible default route modes on an interface are:
talk-listen
talk-only
Example:
X330WAN-2DS1-1(configure)# ip rip default-route-mode talk-only

ip rip poison-reverse (Interface Context)

Use the ip rip poison-reverse command to enable split-horizon with
poison-reverse on an interface. The no form of this command disables the poison-
reverse mechanism.
The split-horizon technique prevents information about routes from exiting the
router interface through which the information was received. This prevents routing
loops.
Poison reverse updates explicitly indicate that a network or subnet is unreachable
rather than implying they are not reachable. Poison reverse updates are sent to
defeat large routing loops.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip rip poison-reverse
78
Set RIP to send and receive default route updates on
the interface.
Set RIP to send but not receive default route updates
on the interface.
Avaya X330W-2DS1 User's Guide