Ip Simulate - Avaya X330W2-DS1 User Manual

The syntax for this command is:
ip distribution access-list-owner <policy-list-number> <owner>
policy-list-number
owner
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
Example:
X330WAN-2DS1-1(configure)# ip distribution access-list-owner
78 "admin"

ip simulate

Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
Note: This command can only be executed from inside the interface context, such as:
the Serial, Loopback, Fast Ethernet and Fabric Fast Ethernet interfaces of the
X330WAN.
The syntax for this command is:
ip simulate <policy-list-number> <direction> [<priority>]
[<dscp-value>]<source> <destination> [<protocol> [<source
port> <destination port> [<established>]]]
policy-list-number
direction
priority
dspc value
source
destination
protocol
Avaya X330W-2DS1 User's Guide
An integer (1..99)
List owner
An integer (100..199) where 0 is the default list.
in|out
fwd0|fwd1|..|fwd7
dscp0|dscp1|..|dscp63
Source IP address
Destination IP address
ip|tcp|udp|integer (1..255)
Policy CLI Commands
113