Chapter 3 Initial Configuration; Connecting The X330Wan; Connecting The E1/T1 Ports; Connecting The Ethernet Port - Avaya X330W2-DS1 User Manual

Chapter 3
Initial Configuration
This chapter describes the initial configuration of the X330WAN, and includes the
following sections:
• "Connecting the X330WAN" - Describes the cables used to connect the
X330WAN.
• "Configuring the X330WAN" - Describes how to configure an X330WAN Fast
Ethernet, T1/E1 interface, or Loopback, and which commands to use to check
and save your configuration.
• "X330WAN Default Settings" - Lists the default settings of the X330WAN.

Connecting the X330WAN

This section describes the cables used to connect the X330WAN.

Connecting the E1/T1 Ports

To connect a E1/T1 module to a network, use an RJ-48C cable, minimum 26 gauge,
to connect the E1/T1 port to an RJ-48C wall jack.

Connecting the Ethernet Port

The X330WAN includes a 10/100Base-T port.
Connect a UTP Category 5 cable with an RJ-45 connector to the 100Base-TX port.
The maximum UTP cable length connected to the 10/100Base-T port is 100 m
(328 ft.).
You can obtain appropriate cables from your local supplier.

Connecting the Console Port

Each Avaya X330WAN module has one serial port on the front panel for connecting
a terminal, a terminal emulator, or a modem.
The serial port on the front panel is labelled "Console" and has an RJ-45 connector.
Connect the X330WAN module to a terminal or a terminal emulator using the
supplied Console cable and the RJ-45 to DB-9 adaptor. To connect a modem, use the
supplied cable and an RJ-45 to DB-25 adaptor.
Avaya X330W-2DS1 User's Guide 19