Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip ospf hello-interval <seconds>
seconds
Example:
ip ospf hello-interval 5
ip ospf priority (Interface Mode)
Use the ip ospf priority command to configure interface priority used in DR
election. The no form of this command sets the OSPF priority to its default. The
default is 1.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip ospf priority <priority>
priority
Example:
priority 17
ip ospf router-id
Use the ip ospf router-id command to configure router identity. The no
form of this command returns the router identity to its default (lowest IP interface
that exists).
Avaya X330W-2DS1 User's Guide
An integer in the range 1 to 65535.
An integer in the range 1 to 255.
Layer 3 CLI Commands
75