Set Time Server; Set Timezone; Show Boot Bank - Avaya X330W2-DS1 User Manual

Output Example:
X330WAN-2DS1-1(super)# set time protocol sntp-protocol
The protocol has been set to SNTP protocol
Output Example:
X330WAN-2DS1-1(super)# set time protocol time-protocol
The protocol has been set to TIME protocol

set time server

The set time server command is used to set the TIME server address.
The syntax for this command is:
set time server <ip address>
ip address

set timezone

Use the set timezone command to assign a timezone name and set the time
difference of your WAN relative to the Coordinated Universal Time (UTC/GMT).
The minutes parameter can only be set to 30.
The syntax for this command is:
set timezone <zone name> <hours|hours:min>
zone name
Output Example:
set timezone GMT -3:30
Timezone set to 'GMT', offset from UTC is -3:30 hours
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".

show boot bank

Use the show boot bank command to display the software bank from which the
Avaya X330W-2DS1 User's Guide
IP address of the TIME server.
Three letter representation of the time zone.
General: Device Commands
57