Duplex (Fastethernet Interface Context) - Avaya X330W2-DS1 User Manual

Note: After setting the controller's mode, this command will:
1. Perform the copy running-config startup-config command.
2. Erase startup-config.
3. Reset the device.
The syntax for this command is:
ds-mode [e1|t1]
e1
t1
Output Example:
X330WAN-2DS1-1(configure)# ds-mode e1
Your startup-config file will be erased!
Your telnet session will be disconnected.
This operation may take a few minutes
The WAN module will reset, in order to make the required
change.
Do you want to continue (Y/N)?
Note: If this command is entered when the correct mode is selected (for example,
entering ds1-mode e1 when the device is already in E1 mode) no errors are
generated.

duplex (FastEthernet interface context)

Use the duplex command to control the duplex setting for the interface.
The syntax for this command is:
duplex {full|half}
full
half
Avaya X330W-2DS1 User's Guide
Sets the device in E1 mode. All controllers are set to operate as E1.
Sets the device in T1 mode. All controllers are set to operate as T1.
This is the default.
Full duplex
Halp duplex
WAN CLI Commands
127