Avaya P330 Leds - Avaya X330W2-DS1 User Manual

After you insert an X330WAN access router module into a powered P330 switch
causing a reset, or after a user-initiated reset is performed, the X330WAN Startup
sequence is as follows:
1 Ten seconds after startup, the ALM LED lights ON for ten seconds, then
switches OF.F
2 The TST LED then lights for twenty seconds and afterwards switches off.
3 Thirty seconds after startup, the ALM LED lights ON again.
Note: LED Number 51 on the Avaya P330 switch should be ON during the self-test
procedure.
The X330WAN module must be inserted completely for the P330 switch to
successfully reset.

Avaya P330 LEDs

Figure 2.1 shows an Avaya P330 Switch front panel and a detailed view of the LEDs
used when an X330WAN is installed. The Avaya P330 Console port is located on the
lower right of the P330 switch.
Another group of LEDs is located on the X330WAN itself.
For a description of the X330WAN's front panel LEDs, see "X330WAN LEDs" in
Chapter 1, Overview.
Avaya X330W-2DS1 User's Guide
Avaya P330 LEDs
15