Calls In A Din/Iso Program - HEIDENHAIN TNC 415 Technical Manual

5.2 Calls in a DIN/ISO program

In a DIN/ISO program, OEM-cycles are not defined via a G- function but via key "D".
The desired OEM-cycle is entered by inputting its number (e.g. 68) and "ENT". The individual
parameters are input via the digital keyboard and entered with "ENT". The definition of the OEM-
cycles ends with "END".
In the case of a "DEF-active" OEM-cycle, the cycle is effective immediately after definition. Once
defined, a "CALL-active" OEM-cycle can be called and hence activated either via G79 or M99.
Example:
% 1000 G71 *
N10 G30 G17 X+0 Y+0 Z–20 *
N20 G31 G90 X+100 Y+100 Z+0 *
N30 G99 T1 L+0 R+2 *
N40 T1 G17 S1000 *
N50 G00 G40 G90 Z+2 M3 *
N60 D68 P1+8 P2+40 P3+60
P4+50 P5–2 P6–20 P7+100 *
N70 G79 *
N99999 % 1000 G71 *
01.98 TNC 407/TNC 415/TNC 425
Definition of blank
For test/program-run graphics
Tool definition
Tool call
Safety clearance
Definition of cycle 68 "Bolt hole circle"
Call cycle
5 OEM-cycles in NC programs 9-11