Dialogs For Oem-Cycles - HEIDENHAIN TNC 415 Technical Manual

2 Dialogs for OEM-cycles

The dialog numbers defined in the dialog blocks of the OEM-cycles determine the text to be
displayed from the dialog file concerned. Which dialog file is active will depend on the dialog
language selected (MP7230) and whether dialogs are read from the EPROM or are stored in the NC
program memory (see the section on "Functions for file management" in the "PLC Programming"
Manual).
The dialog numbers (input: 0 to 127) of the dialog block are assigned to the first 128 lines of a dialog
file.
Example:
DLG-DEF 0/1/.../127
Dialog number in OEM-cycle
0
1
.
.
.
127
Up to 20 characters can be displayed on a dialog line. In all, a maximum of 34 characters may be
input, being reproduced in full in the NC program, but only in abbreviated form on the dialog line.
01.98 TNC 407/TNC 415/TNC 425
Line number of dialog file
1
2
.
.
.
128
2 Dialogs for OEM-cycles
Dialog example
BOLT HOLE CIRCLE
NUMBER OF HOLES
.
.
.
PITCH
9-7