Program Module Manual Tool In - HEIDENHAIN TNC 415 Technical Manual

15.3.5 Program module MANUAL TOOL IN

N -> M or S -> M: Manual tool follows Normal or Special tool.
The old tool is returned to the tool magazine and the operator is prompted to load a manual tool (not
in tool magazine).
No
GRE1 = 0
Yes
STANDBY BACK
Module
Unload GRE1
01.98 TNC 407/TNC 415/TNC 425
Move GRE2 to
spindle and
Old tool out
load SPIREG
to GRE2
Turn changing
As GRE1 is already
arm, load SPIREG zero, this routine has
with GRE1, set
software relevance only.
GRE1 to zero
and return arm
Swap over GRE1
and GRE2
registers
STANDBY BACK
Bring old tool
Module
to magazine
TOOL CALL
feedback
No
M2046 = 1
Yes
Strobe set
again
15 Tool changer
Move axes to
man. change
position
Prompt user to
load tool and press
OK key
No
OK key
pressed
Yes
Load T code
to SPIREG
End
4-251