Bit Commands; Bit Set - HEIDENHAIN TNC 415 Technical Manual

7

3.10 Bit Commands

3.10.1 BIT SET (BS)
Abbreviation for PLC Editor:
Execution time [µs]
Number of bytes
Operands: B, W, D, K
Operation:
With this command, each bit in the Accumulator can be acted on. The addressed bit is set to "1"
through the use of the BS command. The selection (addressing) of the corresponding bit is derived
from the content of the specified Operand or a Constant. In the bit-numbering, bit 0 corresponds to
the LSB and bit 31 the MSB. For operand contents larger than 32, the operand value Modulo 32 is
used, i.e. the integer remainder from the division (operand value)/32.
Example:
Load Doubleword D8 in the Accumulator, set the bit 0 of the Accumulator to "1" and store the result
in Doubleword D12.
Initial state:
Accumulator and operand contents are shown here in hexadecimal notation.
Line Instruction
1 L D8
2 BS K+0
3 = D12
Line 1: Load Doubleword D8 into the Accumulator.
Line 2: The bit specified in the operand is set to 1.
Line 3: The result is stored in Doubleword D12.
7-96 TNC 407/TNC 415/TNC 425
BS (BIT SET)
Byte/Word/Double Constant
0.5 to 0.8 0.3 to 0.4
6
Doubleword D8 = 3E 80
Doubleword D12 = ?
Accumulator Content
xx xx xx
00 00 3E
00 00 3E
00 00 3E
3 Commands
8
(hex)
Operand Content
xx
80 00 00
81
81 00 00 3E
3E 80
81
01.98