Software Types 280 54, 280 56 And 280 58 - HEIDENHAIN TNC 415 Technical Manual

3.5.4 Software types 280 54, 280 56 and 280 58

TNC 415 B/TNC 425:
TNC 415 F/TNC 425 E:
TNC 407:
New functions:
−
Digitizing with TM 110
– Program structuring
– Tool measuring with TT 110
– Complete NC block with Actual Position Capture key
– M124 new
TNC 415 B/TNC 425:
TNC 415 F/TNC 425 E:
TNC 407:
New functions:
– A "PLC" column was added to the tool table. As in the pocket table, relevant PLC data can be
entered here. This column is activated with machine parameter MP7266.17.
– A datum, tool, or pocket table can be searched for to certain values using Module 9092.
– The PLC can activate the geometry data of the tool from W264 with the new marker M2717.
– The elements "Number of cutting edges", "Tolerance for tool length", "Tolerance for tool
radius", "Cutting direction of the tool" and "PLC status" were added to Modules 9093 and 9094.
– During feed pre-control, the positioning window is not evaluated until the current velocity is less
than MP1525. In the previous software versions, the positioning window was not evaluated until
the velocity fell below 0.5 mm/min. Increasing the input value in MP1525 increases the block
processing time.
– Feed pre-control can be activated for all modes of operation with machine parameter MP1391.
This becomes necessary when stiction compensation is to be active in the manual modes of
operation.
– The maximum permissible positional difference between the two gantry axes is defined in
MP855. When this value is exceeded, the blinking error message GROSS POSITIONING ERROR
<AXIS> # A appears. The current positional deviation appears in the LAG display of the slave
axis.
– Module 9171 makes it possible to orient the spindle at a rotational speed defined by the PLC.
– Modules 9040 and 9041 make it possible to read coordinates referenced to a shifted coordinate
system.
– The jog increment can now be limited with Module 9036.
– With the new marker M2827 an EMERGENCY STOP (control-is-ready PLC input signal) can be
suppressed and, instead, all control loops opened and an NC stop executed.
– The new marker M2830 opens all control loops and stops the NC.
– In a digitized data file that has been produced with the TM 110 touch probe, the BLK FORM is
enlarged in the working plane by double the value of the deflection depth (MP6310).
– The radius compensation in the working plane is now also effective in NC blocks with 5-axis
interpolation. The NC block can contain, besides the three non-parallel linear axes, also two rotary
axes.
– Tool measurement with the TT 110 is possible only on machines with controlled spindle
(Spindle orientation).
01.98 TNC 407/TNC 415/TNC 425
280 54x 01
280 56x 01
280 58x 01 Release 6/94
280 54x 02
280 56x 02
280 58x 02 Release 11/94
3 Software 2-23