Tool And Datum Table - HEIDENHAIN TNC 415 Technical Manual

Call:
PS B/W/D/K <Line number in pallet file>
CM 9090
PL B/W/D <Error condition>
0: Files were selected
1: Call not from SUBMIT Job
2: Call after program started
3: Control not in correct mode
4: Pallet file not found
5: No such line in pallet file
6: Wrong type of NC program or point missing
7: NC program not found
8: NC program name not clear
9: Datum table not found
Error status after call: M3171 =
4.7.2 Tool and Datum Table (Module 9092/9093/9094)
Module 9092: Searching for an entry in tables selected for machining (.T/.D/.TCH)
With Module 9092 values can be sought in specific columns in a table (with M status set) selected
for machining. The function supplies the number of the line in which the value is found. This makes
it possible, for example, to search for the vacant pocket (corresponding to T0) in the pocket table
(.TCH).
Constraints:
- The module can only run within a SUBMIT Job.
- The value must be entered as an integer, shifted by the number of definable places after the
decimal point.
- If the value is to be sought again, the starting line must be entered as the line in which the value
was found plus one.
Possible errors:
- The module was not called from a SUBMIT Job.
- There is no file of the specified type that has M status.
- The specified line number is not in the file.
- The specified file type does not exist.
- The specified element does not exist.
- The entered numerical value was not found.
Call:
PS B/W/D/K <File type>
PS B/W/D/K <Element value>
PS B/W/D/K <Element number>
PS B/W/D/K <Line number for beginning the search>
CM 9092
PL B/W/D <Line number> (–1, if M3171=1)
PL B/W/D <Error number>
7-158 TNC 407/TNC 415/TNC 425
0: Files were selected
1: Error condition as Status word
4 PLC Modules 01.98