Data Transmission Software Error Messages - HEIDENHAIN TNC 415 Technical Manual

5.3 Data transmission software error messages

If data is transferred using the HEIDENHAIN - TNC.EXE data transmission program then the
following error messages might be displayed at the TNC:
TRANSFERRED DATA INCORRECT
Attempts to transmit block to control unit has failed four times.
SEARCH FEATURE NOT ALLOWED
Search feature not included in number of acceptable characters.
INSTRUCTION NOT ALLOWED
Request instruction issued by control unit is not allowed.
PROGRAM NOT PRESENT
File requested by control unit does not exist in currently configured access path.
FILE NAME NOT PROGRAM NAME
Name of NC program and name of file do not match.
PROGRAM INCOMPLETE
NC program does not contain an end block.
PROTECTED FILE
File which is protected with read-only or hidden attribute is likely to be overwritten.
DATA CARRIER @: IS FULL
Data carrier >@:< full.
A precise description of this software is given in the Operating Manual of the transmission software.
8-50 TNC 407/TNC 415/TNC 425 5 Error messages 01.98