Software Option; Digitizing With Ts 120; Digitizing With Tm 110 - HEIDENHAIN TNC 415 Technical Manual

New functions will be introduced only in the following software types:
TNC 415B / TNC 425:
TNC 415F / TNC 425 E:
TNC 407:
These software types are therefore supplied as standard.

3.1.3 Software option

HEIDENHAIN offers the "Digitising with TS 120" function as a software option (see chapter "Machine
integration"). An additional software protection module is installed in controls supplied with this
software option. The Id.-Nr. of the logic unit indicates another version. If the software module is
installed, the option is indicated on the screen under the NC and PLC software numbers.
Logic units that have already been delivered can be retrofitted with the software protection module.
Please contact HEIDENHAIN if you wish to buy this option for your existing control. The proper
component model must be ordered for a specific hardware model.

Digitizing with TS 120:

Id.-Nr. of the installation kit
TNC 407 265 313 01
TNC 415A 265 314 01
TNC 415B 286 405 01
TNC 425

Digitizing with TM 110:

Id.-Nr. of the installation kit
TNC 415B 286 405 02
TNC 425
2-8 TNC 407/TNC 415/TNC 425
280 54
280 56
280 58
Id.-Nr. of software module
Id.-Nr. of software module
3 Software
243 02, 243 03, 280 58
246 051 01
246 051 03
NC software
259 96
280 54
NC software
280 54
01.98