Current Tool Axis; Vdu Display - HEIDENHAIN TNC 415 Technical Manual

MP120 Assignment of the analogue outputs
Entry:
MP120.0
MP120.1
MP120.2
MP120.3
MP120.4

1.2.2 Current tool axis

In the NC-block "TOOL CALL" it is determined whether the tool moves parallel to one of the principal
axes X, Y, Z or parallel to the fourth axis. The fifth axis may not be defined as a tool axis. The
markers M2100 to M2103 are used to show which of the four axes is currently defined as the tool
axis. The appropriate marker is then set.
Marker Function
M2100 X-axis is tool axis
M2101 Y-axis is tool axis
M2102 Z-axis is tool axis
M2103 4th axis is tool axis

1.3 VDU display

Machine parameters can be used to select which of the active axes (MP10) should be displayed in
the status window.
The spindle position is displayed only when neither M03 nor M04 is active (see under "Main
spindle").
MP40 VDU display
Entry: %xxxxx
Bit 0 X axis
Bit 1 Y axis
Bit 2 Z axis
Bit 3 4th axis
Bit 4 5th axis
Bit 5 Axis S
4-14 TNC 407/TNC 415/TNC 425
0 = output 1
1 = output 2
2 = output 3
3 = output 4
4 = output 5
5 = output S
X axis
Y axis
Z axis
4th axis
5th axis
0 = not active
1 = active
1 Machine axes
Set Reset
NC NC
01.98