Digitizing With Tm 110 (Only With Digitizing Option) - HEIDENHAIN TNC 415 Technical Manual

Machine Function and input
parameter
MP6270 Rounding of decimal places
Entry: 0 to 2
0 = Output in 0.001 mm increments [1 µm]
1 = Output in 0.01 mm increments [10 µm]
2 = Output in 0.0001 mm increments [0.1 µm]

3.9.2 Digitizing with TM 110 (only with digitizing option)

Machine Function and input
parameter
MP6310 Stylus deflection depth (measuring touch probe)
Entry: 0.1000 to 2.0000 [mm]
MP6320 Counting direction of the measuring system signals
(measuring touch probe)
Entry: %xxx
Bit 0 =
Bit 1 =
Bit 2 =
MP6321 Measuring the centre offset while calibrating the
TM110
Entry: 0 or 1
0 = Calibrate and measure centre offset
1 = Calibrate without measuring centre offset
MP6322 Assignment of touch probe axes to the machine
axes
Entry: 0 to 2
0 = Touch probe axis X
1 = Touch probe axis Y
2 = Touch probe axis Z
MP6322.0
MP6322.1
MP6322.2
MP6330 Maximum stylus deflection (measuring touch
probe)
Entry: 0.1 to 4.000 [mm]
MP6350 Feed rate for positioning to the MIN point and
contour approach
(Measuring touch probe)
Entry: 10 to 3000 [mm/min]
MP6360 Probing feed rate (measuring touch probe)
Entry: 10 to 3000 [mm/min]
MP6361 Rapid traverse in scanning cycle (measuring touch
probe)
Entry: 10 to 10 000 [mm/min]
5-30 TNC 407/TNC 415/TNC 425
X axis 0 = Positive
Y axis 1 = Negative
Z axis
Machine axis X
Machine axis Y
Machine axis Z
3 List of machine parameters
Reaction
Change
via
PLC RUN
CN 123
Reaction Page
Change
via
Page
4-181
4-190
4-190
4-178
4-191
4-191
4-191
4-177
4-191
4-178
4-191
01.98