Tapping - HEIDENHAIN TNC 415 Technical Manual

4.4 Tapping

There are two tapping cycles available in the control:
•
tapping with floating tap holder and
•
rigid tapping.
Tapping with floating tap holder is possible for both analogue and BCD-coded spindle-speed output.
Rigid tapping is only possible for analogue spindle-speed output.
The tapping cycle is defined in the NC-program and can be called with CYCL CALL (M03). Tapping is
adjusted to the dynamic behaviour of the machine by machine parameters.
4-112 TNC 407/TNC 415/TNC 425 4 Main Spindle 01.98